In short
- Best all-rounder: SUNLU PLA+.
- Best price: ELEGOO PLA.
- Tough and reliable: eSUN PLA+.
- Beautiful matte finish: Polymaker PolyTerra.
How we choose: we have not tested every product ourselves. We look at specifications, ease of use, what it costs per print hour (using this site's calculation method), availability in the Netherlands and the experiences of many buyers.
Comparison
| Filament | Type | Best for |
|---|---|---|
| SUNLU PLA+ | PLA+ | everyday use, slightly tougher |
| ELEGOO PLA | PLA | printing as cheaply as possible |
| eSUN PLA+ | PLA+ | functional parts |
| Polymaker PolyTerra | matte PLA | decoration without shine, less visible layer lines |
The four top picks
1. SUNLU PLA+
Best for: almost everything you print day to day.
- Pros: tougher than regular PLA, lots of colours, lots of good reviews.
- Cons: prints slightly hotter than regular PLA.
2. ELEGOO PLA
Best for: printing as cheaply as possible.
- Pros: sharp price, accurate diameter.
- Cons: regular PLA is a bit more brittle than PLA+.
3. eSUN PLA+
Best for: parts that need to take a knock.
- Pros: tough, well-known brand, consistent quality.
- Cons: fewer colours than some competitors.
4. Polymaker PolyTerra
Best for: decoration and figures.
- Pros: matte finish hides layer lines, beautiful colours.
- Cons: slightly less strong than PLA+.
PLA, PLA+ or matte PLA?
- PLA: cheapest and easiest, but somewhat brittle.
- PLA+: tougher, for only a few euros more per kilo. The best choice for most people.
- Matte PLA: great for decoration; layer lines are less noticeable.
- Does your print need to handle heat or be used outdoors? Then look at PETG.
What does PLA cost per print?
At € 20 per kilo, a 40 gram phone stand costs about € 0.80 in filament. You get roughly 23 phone stands from one spool; see how many prints from 1 kg of filament.
Links to Amazon.nl are affiliate links: if you buy something through such a link, 3dprintkosten.nl receives a small commission. The price stays the same for you. Prices change; check the current price on Amazon.
Frequently asked questions
What is the difference between PLA and PLA+?
PLA+ is PLA with additives that make it slightly tougher and less brittle. It prints almost the same, often 5 to 10 degrees hotter.
What does good PLA filament cost?
Usually € 18 to € 25 per kilo. Multipacks are often cheaper per kilo.
Does the brand matter much?
Less than you might think, as long as the diameter is accurate and the spool is neatly wound. With the brands on this page, that is usually fine.
Calculate what your prints cost
The calculator instantly shows what a print costs, including electricity, wear and failed prints.
Calculate the cost of your print →